GRAPHTEC GL500 User Manual page 55

w w w w w CRNT Settings
This menu is used to set the conditions for low-speed data capture.
CRNT (CURRENT) Menu Structure
Setting
Sampling Interval 1, 2, 5, 10, 20, 50, 100, 200, 500 ms 1, 2, 5, 10, 20, 30 s
1, 2, 5, 10, 20, 30 min 1h
Capture Ddestination Memory, PC card
File Name Specify file (only when PC card has been selected)
• File Type: GBD, CSV
• File : Folder name, file name
Trigger Settings
Start Source: Off, Amp, Date, Ext.
Stop Source: Off, Amp, Date, Ext., Time, Ev. full
Repeat Off, On
Alarm Settings
Combination OR, AND
Amp Settings H, L, Win In, Win Out
[Current] Settings
Sampling Interval ................ Specifies the sampling interval for data capture.
Capture Destination ............ Specifies the data capture destination.
Selections available
Memory: 4 MB (2 Mwords)
The amount of data that can be captured decreases as the
number of channels used increases.
PC card: Use commercially-available PC cards in the built-in PCMCIA
card slot to capture data. The amount of data that can be
captured is determined by the memory capacity of the card
used. For details on the types of cards that can be used, see
Section 5.1, "Standard Specifications".
CHECKPOINT
When the captured data is Binary data, use 1 data = 2 bytes as a reference.
Accordingly, if the memory is 12 Mbytes, approximately 6 Mwords of data
can be captured. However, since there is also some auxiliary data present,
data larger than this reference figure will be captured. In addition, when the
Excel data format is used, the data will increase to 7-8 times in size. The
data capture time will be shorter than that for Binary data.
Settings and Measurement
Setting method
ENTER→Select→ENTER
ENTER→Select→ENTER
ENTER→Select→ENTER
ENTER→Select→ENTER
ENTER→Select→ENTER
ENTER→Select→ENTER
ENTER→Select→ENTER
ENTER→Select→ENTER
3-17