Table of Contents
Advertisement
MOUNTING THE UNIVERSAL BRACKET
Position the bracket on the steel cab support beam beneath the front of the cab. Drill holes to fit the
mounting bracket pattern and attach the universal mounting bracket to the machine using the pro-
vided 3/8" hex-head bolts. Figure below shows the bracket mounted to the machine with the valve
and hoses attached, and cables run between the valve and mounting beam.
MOUNTING THE HYDRAULIC VALVE
Note: Prior to attaching the steering assist valve to the mounting bracket, remove the existing
A, B, and T port fittings and install the provided larger fittings. This accomodates for the
larger hose sizes used in this installation. Also, remove the PS port fitting and replace it with
the provided hex-head cap plug.
Position the hydraulic valve on the universal bracket over the top of the proper hole pattern. Secure
the valve to the bracket using the provided metric bolts and lock washers.
3
Advertisement
Table of Contents
