Table of Contents
Advertisement
•
•
•
NOTES: When using TP cable in bundles or conduits, consider the following:
LockIt HDMI Lacing Bracket Installation
The Extron LockIt lacing bracket secures a
standard HDMI cable to most HDMI devices.
NOTE: The HDMI device must have an
To securely fasten an HDMI cable to a device:
1.
2.
3.
4.
5.
If you are not using XTP DTP 24 cable, at a minimum, Extron recommends 24 AWG,
solid conductor, STP cable with a minimum bandwidth of 400 MHz.
Terminate cables with shielded connectors to the TIA/EIA-T568B standard.
Use no more than two pass-through points, which may include patch points, punch
down connectors, couplers, and power injectors. If these pass-through points are
required, use Category 6 or 6a shielded couplers and punch down connectors.
•
Do not exceed 40% fill capacity in conduits.
•
Do not comb the cable for the first 65 feet (20 meters), where cables are
straightened, aligned, and secured in tight bundles.
•
Loosely place cables and limit the use of tie wraps or hook-and-loop fasteners.
•
Separate twisted pair cables from AC power cables.
HDMI connection mounting screw for
this bracket to be used.
Plug the HDMI cable into the panel
connector (see
in the image at right).
1
Loosen the HDMI connection mounting
screw from the panel enough to allow the
LockIt lacing bracket to be placed over
it (
). The screw does not have to be
2
removed.
Place the LockIt lacing bracket on the screw
and against the HDMI connector (
tighten the screw to secure the bracket.
Loosely place the included tie wrap
around the HDMI connector and the
LockIt lacing bracket as shown (
While holding the connector securely against the lacing bracket, tighten the tie wrap,
then remove any excess length.
ATTENTION:
•
Do not overtighten the HDMI connection mounting screw. The shield to which
it is fastened is very thin and can easily be stripped.
•
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
1
3
4
3
), then
3
).
4
DTP2 T 204 Switcher • Installation
2
16
Advertisement
Table of Contents
