Table of Contents
Advertisement
LockIt HDMI Cable Lacing Bracket
LockIt lacing brackets are provided to secure the HDMI cables to the rear panel connectors
as shown in figure 11, below. The configuration of the HDMI connectors and supporting
fasteners on the MPS 602 rear panel require using a top mount installation for HDMI input 3
and a single or stacked side mount installation for HDMI inputs 4 and 5.
To secure a single HDMI cable in HDMI inputs 3 and 4:
1.
2.
3.
4.
To secure two HDMI cables in HDMI inputs 4 and 5:
1.
2.
3.
4.
4
5
1
Figure 11.
Loosen the HDMI connection mounting screw from the panel enough to allow LockIt
lacing bracket placement.
ATTENTION:
•
Do not remove the HDMI connection mounting screw.
•
Ne retirez pas la vis de montage de la connexion HDMI.
•
Do not overtighten the HDMI connector mounting screw. The shield it fastens to
is very thin and can easily be stripped.
•
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
Plug the HDMI cable into the panel connection.
Place the LockIt lacing bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket.
Loosely place the included tie wrap around the HDMI connector and LockIt lacing
bracket. Hold the connector securely against the lacing bracket and tighten the tie
wrap, then remove excess length.
Loosen the HDMI connection mounting screw from the panel near HDMI input 4
enough to allow LockIt lacing bracket placement.
Insert both HDMI cables into the panel
Use a single LockIt lacing bracket to the side of the cable.
Secure both with the tie wrap as shown in the "Stacked" configuration in figure 11.
3
2
3
Top
Lockit Lacing Bracket Installation
4
2
4
Side
MPS 602 • Installation
4
4
4
Stacked
11
Advertisement
Table of Contents
