Extron electronics DTP2 T 204 User Manual page 43

Command
Channel Mute (Deselect) Mode — via contact and tally pins
Set mode
View mode
X@
KEY: = Channel mute on and off
X3&
= Tally pin mode
EDID Minder
View EDID in hex format
View EDID native resolution
Example
X!
KEY: = Inputs
X*
= Current EDID information in
hexadecimal
X1)
= Current EDID native resolution
and refresh rate
ASCII Command Response
(Host to Switcher) (Switcher to Host)
EX@ X3& }
* MUTM Mutm
E } X@
MUTM
In verbose modes 2 and 3:
Mutm
0 = Unmute the contact input channel. (Selects 0 for
1 = Mute the contact input channel.
0 = Always on (default)
1 = Off when channel is muted
2 = Blink when channel is muted
E X! } X*]
R EDID
E X! } X1)]
N EDID
E X! }
N EDID 1600x1200 @ 60.0 Hz
1 through 4
128 or 256 bytes of raw hex data
Native resolution and refresh rate from selected EDID.
Example: 1920x1200 @60Hz
DTP2 T 204 Switcher • Remote Configuration and Control
Additional Description
X@ X3&] Mute (deselect) or unmute (select)
*
the connected contact input and
set the tally pin mode (
input).
Set the behavior of the connected
tally indicator to
output mute
X3&]
*
View channel mute mode
tally mode
X@ X3&]
*
View the current EDID assignment
for input
(128 or 256 bytes).
X*
hex.
Show native resolution and refresh
rate
applied to input
]
X3&
) for the
X1*
when the
X@
is set to 1.
X@
and
X3&
.
X3&
.)
X!
in hexadecimal
= current EDID information in
X1)
of the EDID currently
X!
.
35