Extron electronics DTP2 T 204 User Manual page 37

X2^
= Password
Length can be 0 to 128 characters. All human-readable characters are permitted except "|".
Passwords are case-sensitive and cannot be a single space.
NOTES:
•
In response to the View administrator password and the View user password
commands,
displayed if no password exists.
•
The factory configured passwords for all accounts on this device have been set to
the device serial number. In the event of a complete system reset, the passwords
convert to the default, which is extron.
X2&
= Port configuration (DTP2 insertion)
0 = RS-232 pass-through (default)
1 = Ethernet pass-through
2 = Host mode
X2*
= Serial port number
01 = Remote RS-232 port
02 = (Not used)
03 = RS-232 UART port 1 (TP output)
X2(
= Baud rate — 300, 600, 1200, 1800, 2400, 3600, 4800, 7200, 9600 (default), 14400, 19200,
28800, 38400, 57600, or 115200
X3)
= Parity — Odd, Even, None (default), Mark, Space
(Use only the first letter.)
X3!
= Data bits — 7 or 8 (default)
X3@
Stop bits — 1 (default) or 2
=
X3#
Port timeout intervals — 1 to 65000 in 10 second increments: 1 = 10 seconds.
=
Default is 30 = 300 seconds = 5 minutes.
X3$
= Start point for UART ports
Default = 1999
X3%
= Firmware version to the second decimal place (n.nn)
X3&
= Tally pin on channel mute
0 = Always on (default)
1 = Off when muted
2 = Blink when muted
X4!
= Auto Switch Priority
1 = input 1
2 = input 2
3 = input 3
4 = input 4
X4@ Auto Switch Timeout for mode 2 — Number of seconds the switcher delays before switching
=
to the most recently selected input.
0 to 500 seconds (in 1 second intervals)
0 = Immediate switch (no delay)
Default = 3 seconds
X4#
Prefix (subnet mask bits). Subnet mask 255.255.0.0 is represented as a prefix value by
=
/16 . The default subnet mask bits response for a CISG command (on IPv4) is /16:.
X4$
= TP mode
0 = DTP mode
1 = HDBT mode
DTP2 T 204 Switcher • Remote Configuration and Control
X2^
is displayed as **** if a password exists. An empty line is
29