Extron electronics DTP2 T 204 User Manual page 23

3. Plug the 5-pole connector into the Over TP port on the rear panel of the switcher.
4. Connect the other end of the cable to the appropriate computer or control system port.
NOTES:
•
The RS-232 and IR connectors share the ground pole and the data from both can
be transmitted simultaneously.
• The IR Tx and Rx line pairs and the RS-232 Tx and Rx line pairs must each cross
once between their connectors and the source or destination.
• The length and preparation of exposed wires is important (see the wiring
ATTENTION:
Wiring the TP Connector and Cable Recommendations
The TIA/EIA T 568B wiring standard is detailed in figure 11. Use this standard to terminate
the TP cable with RJ-45 connectors.
Side
Figure 11.
ATTENTION:
Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201
•
cable to link the XTP products or with DTP transmitters or receivers. The
DTP2 T 204 does not work properly with these cables.
• N'utilisez pas le câble audiovisuel Skew-Free UTP version améliorée UTP23SF-4
Extron ou le câble STP201 pour relier les produits XTP à des émetteurs ou
récepteurs DTP. Le DTP2 T 204 ne fonctionne pas correctement avec ces câbles.
Supported cables
The DTP2 T 204 is compatible with shielded twisted pair (STP) and unshielded twisted pair
(U/UTP) cable. However, Extron strongly recommends that you use STP cable to achieve
best performance.
Cable recommendations
Extron recommends using the following practices to achieve full transmission distances up
to 330 feet (100 meters) and reduce transmission errors.
Use the following Extron XTP DTP 24 STP cables and DTP 24 connectors for the best
•
performance:
XTP DTP 24/1000
•
XTP DTP 24P/1000 Plenum 1000 feet (305 meters) spool
•
XTP DTP 24 Plug
•
starting on page 11 for details).
Pins:
RJ-45
12345678
Connector
TIA/EIA T
568B
Pin Wire color
1 White-orange
Orange
2
3 White-green
4 Blue
5 White-blue
6 Green
Insert
7 White-brown
Twisted
8 Brown
Pair Wires
TP Cable Termination
Non-Plenum 1000 feet (305 meters) spool
Package of 10
DTP2 T 204 Switcher • Installation 15