Rear Panel Features - Extron electronics DTP2 T 204 User Manual

6.
7.
8.
9.
10.
11.

Rear Panel Features

A
B
C
D
E
Figure 3.
A
B
C
For IR control and bidirectional over TP RS-232, connect a serial RS-232 signal,
a modulated IR signal, or both into the 3.5 mm, 5-pole captive screw connector
(see Wiring for Over TP RS-232 and IR Control
Connect the computer to one of the following DTP2 T 204 ports to configure and
control the switcher via SIS commands or PCS (Config and LAN ports only):
• RS-232 port — 3-pole captive screw connector for serial RS-232 control (see
Wiring for RS-232 Control
• Config port — USB mini-B connector for USB control
• LAN port — RJ-45 connector for Ethernet control (see
on page 9).
Power on the output display.
Connect power to the switcher (see
(Optional) Configure the EDID Minder (see
Power on the source devices.
DTP2 T 204
POWER
1 2 3
12V
2.2 A MAX
INPUTS
A B
Power input connector
HDMI input connectors
DTP2 and HDBT output connector
TP mode switch
Over TP RS-232 and IR connectors
DTP2 T 204 Rear Panel
Power input connector — Plug the provided external 12 VDC, 3 A power supply into
this 2-pole, 3.5 mm captive screw connector and into an AC power outlet.
HDMI input connectors — Connect HDMI video input sources to these female Type A
HDMI connectors.
NOTE: LockIt cable lacing brackets are provided with the DTP2 T 204 units. These
brackets secure the HDMI cables to the rear panel connectors and reduce stress
on the connectors, preventing signal loss due to loose cable connections.
DTP2 and HDBT output connector — Connect the input of a DTP2 or HDBaseT
compatible device to this RJ-45 connector. The connector contains two LEDs:
• Signal LED — This green LED lights green the unit is outputting a TMDS clock
signal.
• Link LED — This amber LED blinks to indicate a valid link is established between
the units.
on page 14).
on page 12 for connection procedures)
Powering on the Switcher
EDID Minder
I
O V E R T P
HDBT
SEND POWER
R S - 232 IR
Tx Rx G Tx Rx
DTP
SIG LINK
4 CONT
1 2
C T C T +V
OUT
C D E F
Contact closure input and tally
F
output ports
Remote RS-232 connector
G
LAN (Ethernet) connector
H
Send Power mode switch
I
DTP2 T 204 Switcher • Installation
LAN (Ethernet) connector
on page 18).
on page 20).
F
5 6
OFF
C G T +V C
G T +V
REMOTE
3 4 RS-232
C T C T Tx Rx G
LAN
G H
6