Extron electronics DTP2 T 204 User Manual page 47

Command
Set IP Address, Subnet Mask, and Gateway Address (in a single command)
Set IP address
Set IP address and subnet
mask
Set IP, subnet, and gateway
addresses
View IP, subnet, and
gateway addresses
NOTE:
Setting any values with the CISG command changes DHCP from On to Off and the Cisg response is followed by a
Boot2 response.
X2@
KEY: = IP Address (xxx.xxx.xxx.xxx) Leading zeros in each of the 4 fields are optional in setting values and
are expressed in returned values.
Factory Default IP address: 192.168.254.254
Default Gateway IP address: 0.0.0.0,
Default DNS Server UP address: 0.0.0.0
=
X4#
Prefix (subnet mask bits)
Passwords
NOTE: The factory configured passwords for all accounts on this device have been set to the device serial number. In the
event of a complete system reset, the passwords convert to the default, which is extron. Passwords are case sensitive.
Set administrator
24
password
Clear administrator
password 24
View administrator
24
password
14,24
Set user password
Clear user password 24
24
View user password
X2^
KEY: = Password
ASCII Command Response
(Host to Switcher) (Switcher to Host)
E X2! }
1* CISG Cisg•1*
E X2! X4# }
1* / CISG Cisg•1*
E X2! X4# X2$ }
1* / * CISG
E } X2!
1CISG
In verbose modes 2 and 3:
Cisg•1*
EX2^ }
CA Ipa•
E }
•CA Ipa•
E } X2^]
CA
In verbose modes 2 and 3:
Ipa
EX2^ }
CU Ipu•
E }
Ipu•
•CU
E } X2^]
CU
In verbose modes 2 and 3:
Ipu
Length can be 0 to 128 characters. All human-readable characters are permitted except
|. Passwords are case-sensitive and cannot be a single space. In response to the View
administrator password and the View user password commands,
as **** if a password exists. An empty line is displayed if no password exists.
DTP2 T 204 Switcher • Remote Configuration and Control
X2! X4# X2$]
/ *
X2! X4# X2$]
/ *
X2! X4# X2$]
Cisg•1* / *
X4# X2$]
/ *
X2! X4# X2$]
/ *
Subnet 255.255.0.0 is represented as a Prefix
value by /16 . Default subnet mask bits response
E
for CISG command = /16 .
X2^]
]
X2^]
X2^]
]
X2^]
Additional Description
X2!
View IP address , subnet
X4#
mask prefix , and gateway
X2$
address at one time.
X2^
Set administrator password
Remove the administrator
password.
View the administrator password.
For the view password command
only:
X2^
= **** if a password exists,
an empty line if no password
exists.
X2^
Set user password .
X2^
Remove user password .
View the user password.
For the view password command
only:
X2^
= **** if a password exists,
an empty line if no password
exists.
X2^
is displayed
.
39