Connecting Using A Show Me Cable; Lockit Hdmi Cable Lacing Bracket Installation - Extron electronics SW HD 4K PLUS Series User Manual

Connecting Using a Show Me Cable

The CONTACT/TALLY connectors can also be used with Extron Show Me cables. Figure 9
shows how to wire a Show Me cable to a contact input. For each Show Me cable:
Red
SW2 and SW4 HD 4K PLUS
Figure 9.
•
•

LockIt HDMI Cable Lacing Bracket Installation

The Extron LockIt lacing bracket secures a
standard HDMI cable to most HDMI devices.
NOTE: The HDMI device must have an
To securely fasten an HDMI cable to a device:
1.
2.
3.
4.
5.
CONTACT/TALLY
Connector
1 2
Black
C T C T +V
Show Me
Cable
Connecting Contact and Tally Ports Using a Show Me Cable
Connect the red pigtail to the C pin corresponding to the input being used.
Connect the black pigtail to the T pin of the same input.
HDMI connection mounting screw for
this bracket to be used.
Plug the HDMI cable into the panel
connection.
Loosen the HDMI connection mounting screw
from the panel enough to allow the LockIt
lacing bracket to be placed over it. The screw
does not have to be removed.
Place the LockIt lacing bracket on the screw
and against the HDMI connector, then tighten
the screw to secure the bracket.
Loosely place the included tie wrap around
the HDMI connector and the LockIt lacing
bracket as shown.
While holding the connector securely
against the lacing bracket, tighten the tie
wrap, then remove any excess length.
ATTENTION:
Do not overtighten the HDMI connection mounting screw. The shield to which
•
it is fastened is very thin and can easily be stripped.
• Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
CONTACT IN/TALLY OUT
Connector
1
Black
C T G
Red
2
Show Me
Cable
C G T
SW6 and SW8 HD 4K PLUS
1
3
4
SW HD 4K PLUS Series • Installation
2
3
12