Table of Contents
Advertisement
LAN (Ethernet) connector — Use an RJ-45 cable to connect this jack to a LAN for
H
control of the switcher via Ethernet.
ATTENTION:
•
Do not connect this device to a telecommunications network.
•
Ne connectez pas cet appareil à un réseau de télécommunications.
•
Use a straight-through cable for connection to a switch, hub, or router.
•
Use a crossover cable or a straight-through cable for connection directly to a PC.
Wire the connector as shown in figure 4.
Pins:
12345678
Pin
RJ-45
Connector
Insert Twisted
Pair Wires
Figure 4.
Wiring for Ethernet Control
Send Power mode switch — In a DTP2 transmitter to DTP2 receiver configuration,
I
set this toggle switch to the Up (Send Power) position on the powered DTP2 unit to
enable sending remote power to the far end. Set the toggle switch to the Down (Off)
position on the DTP2 unit receiving power.
ATTENTION:
•
The DTP2 T 204 is configured to output power to DTP2 models only. If
connected to a non-DTP2 device, set the SEND POWER toggle switch
to the Off (Down) position. Failure to turn the power OFF will damage the
connected non-DTP2 device (see
•
Le DTP2 T 204 est configuré pour fournir une alimentation aux modèles
DTP2 uniquement. S'il est connecté à un autre appareil, veuillez positionner
l'interrupteur à bascule sur « Off » (Down). Si l'interrupteur n'est pas positionné
sur Off, vous risquez d'entraîner la défaillance de l'appareil non DTP2 connecté
(voir figure 5).
NOTES:
•
When the output is configured for DTP mode, remote power is available only
if both the transmitter and the receiver are from the DTP2 series.
•
When the output is configured for HDBT mode, remote power is not available
and both the transmitter and receiver require their own 12 VDC power supply.
Straight-through Cable
(for connection to a switch, hub, or router)
End 1
End 2
Wire Color
Pin
Wire Color
1
white-orange
1
white-orange
2
orange
2
orange
3
white-green
3
white-green
4
blue
4
blue
5
white-blue
5
white-blue
6
green
6
green
7
white-brown
7
white-brown
8
brown
8
brown
TIA/EIA-T568B
T568B
figure 5
DTP2 T 204 Switcher • Installation
Crossover Cable
(for direct connection to a PC)
End 1
End 2
Pin
Wire Color
Pin
Wire Color
1
white-orange
1
white-green
2
orange
2
green
3
white-green
3
white-orange
4
blue
4
blue
5
white-blue
5
white-blue
6
green
6
orange
7
white-brown
7
white-brown
8
brown
8
brown
T568B
T568A
on the next page).
9
Advertisement
Table of Contents
