Lockit Hdmi Cable Lacing Bracket - Extron electronics MPS 601 User Manual

Media presentation switcher
Hide thumbs Also See for MPS 601:
Table of Contents

Advertisement

LockIt HDMI Cable Lacing Bracket

The included LockIt lacing brackets secure the HDMI cables to the rear panel connectors
as shown in figure 8, below. The configuration of the HDMI connectors and supporting
fasteners on the MPS 601 rear panel require using a top mount (HDMI output, see figure 9,
Top) and a stacked side mount (HDMI inputs 3 and 4, and inputs 5 and 6) installation to
secure the four inputs and single output.
To secure a single HDMI cable in HDMI inputs 3 and 5:
1.
2.
3.
4.
To secure two HDMI cables in HDMI inputs 3 and 4 or inputs 5 and 6:
1.
2.
3.
4.
3
4
1
A single LockIt bracket can be used to secure two HDMI connectors in a stacked
configuration as shown in figure 9.
Figure 9.
Loosen the HDMI connection mounting screw from the panel enough to allow LockIt
lacing bracket placement (see figure 8,
ATTENTION:
Do not remove the HDMI connection mounting screw.
Ne retirez pas la vis de montage de la connexion HDMI.
Do not overtighten the HDMI connector mounting screw. The shield it fastens to
is very thin and can easily be stripped.
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
Plug the HDMI cable into the panel connection (
Place the LockIt lacing bracket on the screw and against the HDMI connector (
tighten the screw to secure the bracket.
Loosely place the included tie wrap around the HDMI connector and LockIt lacing
bracket (
). Hold the connector securely against the lacing bracket and tighten the tie
4
wrap, then remove excess length.
Loosen the HDMI connection mounting screw from the panel near HDMI input 4
enough to allow LockIt lacing bracket placement.
Insert both HDMI cables into the panel.
Use a single LockIt lacing bracket to the side of the cable.
Secure both with the tie wrap as shown in the stacked configuration in figure 8.
3
4
2
1
3
2
Figure 8.
Lockit Lacing Bracket Installation
M I
H D
M I
3
H D
Top
Top
Lockit Lacing Bracket Examples
).
1
).
2
3
2
3
3
2
3
3
Side
Side
3
3
3
4
3
Stacked
Stacked
MPS 601 • Installation
), then
4
9

Advertisement

Table of Contents
loading

Table of Contents