Using A Mouse - Vitek Transcendent VT-TTR Series Manual

Transcendent DVR Series
devices with multiple remote controls, you will need to configure the device ID, please refer to
① Activate remote control to control the device: Point the IR sensor of the remote control
below steps:
towards the IR receiver on the front panel, press the number 8 key twice on the remote,
input device ID of the HD TVI Hybrid DVR to be controlled (Range from: 0-65535; the
② You can check the device ID of the HD TVI Hybrid DVR from SetupBasicSystem
default device ID is 0) and press ENTER to confirm.
interface. You can also set multiple devices with the same device ID, however this can
cause interference if the devices are kept close to each other.

2.3 Using a Mouse

① Double-click on any camera window to see full screen. Double-click again to return to the
During live:
② Right click to reveal the control menu on the screen. Right click again to hide the menu.
previous screen.
① Click to enter a particular option. Right click to cancel the option or return to the previous
In Configuration:
② In order to input a value in a particular screen, move cursor to the input box and click.
menu.
③ Supports mouse drag. Take setting up motion detection area for example: Click
customized, hold down the left button and drag to set motion detection area.
In Playback:
Click to choose the options. Right click to return to live mode.
In Backup:
Click to choose the options. Right click to return to previous picture.
Mouse is the default tool for all operations unless an exception as indicated.
Using Virtual Keyboard
1~0：Digital number.
11