Vitek Transcendent VT-TTR Series Manual page 35

② Enable motion alarm, set alarm hold time which refers to the time utill which the
system will wait for further detection of motion. e.g. If the holding time is set to 10
seconds, once the system detects motion, it will go to alarm but would not detect
any other motion alarm (specific to channel) until 10 seconds. If there is other
motion detected during this period it is considered it as continuous movement,
otherwise it will be considered as a single detection.
③ The setup steps of motion trigger are similar to "Alarm Handling" (See Sensor
Alarm Handling setting for more details).
④ After clicking Area button, a dialog box will pop up as below.
⑤ In the Area interface, you can drag slide bar to set the sensitivity value (1-8). The
higher the value the more sensitive it is to motion. Since the sensitivity is influenced
by color and time (day or night), you can adjust its value according to the particular
conditions. Left click the grid and drag to delete area. Click
whole area as detection area. Click
icon to test the sensitivity as per the particular conditions. Once motion is
sensed, it displays a figure icon. Click
to exit the current interface.
Note: Prior to setting motion detection field it is recommended that you click
Transcendent DVR Series
icon to clear the set detection area. Click
icon to save the setting. Click
34
icon to set the
icon