Qualifications Of Operator; Conditions Of Mounting Mower On Tractor; Transport - SaMASZ KDD 861 Operator's Manual

In the event of any break in the equipment operation, turn the drive off. Shut down the tractor's

engine, take the ignition key off, leave the cabin and make sure there are no unauthorized
persons in the cabin and close the door.
It is forbidden to leave the tractor's cabin when driving.

In the event of a serious fault, stop the machine's drive, turn off the tractor's engine and take out

the ignition key. Then contact SaMASZ technical service, and if an accident (here road
accident) occurs, follow all applicable first aid procedures and contact responsible authorities.
Mower should be kept clean, so as to avoid danger of fire.

4.2.

Qualifications of operator

To provide safe machine operation each person being the machine operator must meet the
following requirements:
Operator should hold driving license, have ability to drive vehicles safely and know road traffic

rules.
Operator must be in proper physical condition to be able to operate the machine.

Operator must not be under the influence of alcohol, drugs and medicines, which all have

influence on vehicle driving and machine operation.
Operator should be familiarized with this manual and follow its provisions.

Operator should be familiar with working principles of both the tractor and the machine, and be

able to recognize and avoid hazards resulting from operation of the aggregate.
4.3.

Conditions of mounting mower on tractor

Prior to the mounting operation, check whether the tractor's and the mower's hitch categories are

compatible and make sure that tractor's hitch load is adequate for the machine aggregated.
Prior to mounting the machine, examine technical condition of the mower's hitch assembly and

tractor's 3-point linkage.
Use only genuine pins and cotters to mount the mower on a tractor.

4.4.

Transport

Front axis of the tractor should be weighted to keep the balance. If needed, use weights on front

axis.
Every position change of the mower can only be done when there is nobody around (pay

particular attention to children).
For transport period put warning plate with combined lights and reflectors and warning triangle

on the mower.
During transport always put the mower to transport position. See chapter 5.3.

Before putting the mower to transport position make sure, that the tractor's PTO is turned off

and all rotating parts have come to complete standstill.
Always adjust your driving speed to the current road conditions and according to local traffic

rules.
Permissible speed is 25 km/h and it cannot be exceeded.

No person and no objects must remain on the mower when driving or transporting.

When taking turns pay particular attention and consider the machine's weight and dimensions.

Bear in mind that when transporting the machine in areas where high voltage lines are present,

exercise special caution as touching the lines with the aggregate is likely.
Operator's manual
- 14 -
Double-sided disc mowers
with central suspension