Taking Turns Over Swaths; Detaching The Mower From The Tractor; Storing The Machine - SaMASZ KDD 861 Operator's Manual

5.9.3. Taking turns over swaths

Lift the mower with hydraulic cylinder (Pos. 2, Fig. 3) and take turn. The mower does not
need to be additionally lifted by tractor's 3-point linkage (Fig. 26).

5.10. Detaching the mower from the tractor

WARNING!
While detaching, make sure there is no person in between the mower and the
tractor.
To detach the mower from the tractor do the following:
turn off the cutterbar drive, tractor's ignition and take the tractor's ignition key out,

reduce pressure in unloading system,

lift the machine so it is possible to insert support feet and secure them with cotters,

lower the mower by means of the tractor's hydraulic assembly and place it on a firm and level

ground,
secure the tractor against free runaway,

dismount PTO shaft and place it on PTO shaft holder,

disconnect the machine's hydraulics and wiring system from the tractor,

disconnect the upper link,

disengage the machine from hangers of the tractor's lower links by lifting the three-point

linkage,
carefully drive the tractor away.


5.11. Storing the machine

Mower should be stored in dry places, secured against precipitation. If the mower is expose to
precipitation, maintenance work should be carried out during storing. In order to save storing
area e.g. under shed, houses, etc. the mower may be stored in vertical position (Fig. 27) but always
on paved surface. Storing the mower on an unpaved surface is inadmissible, for it may cause
the mower to lose stability and in consequence lead to falling for what the manufacturer shall not
bear any responsibility.
NOTICE:
When stored for longer period (e.g. in winter season), the machine should be
erected in standstill position on paved surface (Fig. 27) (tighten cylinders).
Operator's manual
Fig. 26. Mower KDD when taking turns
- 42 -
Double-sided disc mowers
with central suspension