6.10.2. Conveyor belt replacement and adjustment instruction
Mower KDD with conveyors must be suspended onto tractor. Lean the mower with use of
upper connector (cylinder) maximally to the front – in order to increase the distance between
conveyor and the ground.
I.
Steps to be taken when transporting in operating position (horizontal).
1. Using a marker, mark lines on millimetre measures – decal 77 (if belts worked well).
2. Loosen tightening roller mechanism – screws M10 - S
screw M12 – S
by approx. 30 mm / 3'11" (Fig. 44).
2
Driving roller hydraulic
engine
(do not adjust)
II. Steps to be taken when transporting in vertical position. Mower shall be leaned to the front
so the distance between conveyor and the ground is approx. 1 m / 3' 3".
1. Loosen screws M10 – S
tensioners (Fig. 45).
S
S
1
Operator's manual
, nuts M12 – N
1
2
N
2
Double-sided disc mowers
with central suspension
, nuts M12 – N
1
S
1
N
Fig. 44.
adjustment screws M12 – S
2
Fig. 45.
- 54 -
and loosen adjustment
2
measure
30 mm
of front
2
S
S
1
N
2
S
2
2