Regulation Of Cutterbar's Pressure On The Ground By Means Of Support Springs - SaMASZ KDD 861 Operator's Manual

a)
Fig. 23. Operating either a) with belt conveyors or b) without
NOTICE:
DO NOT pull the cutterbar in other way (towards the tractor), because it will
lead to cutterbar's premature wear or even its damage.

5.8.1. Regulation of cutterbar's pressure on the ground by means of support springs

Pressure on the ground is regulated by changing the tension of support springs.
Decreasing the pressure of the cutterbar on the ground is done together with increasing the
tension of the support springs by moving the the lock in the next hole on the rod towards the springs
(Fig. 24). Increasing the cutterbar's pressure on the ground is caused by decresing the tension of
support springs by moving the lock towards the rod's end.
Regulation may only be performed when the machine is in vertical position (Fig. 27).
Operator's manual
Fig. 24. Regulation of support springs
- 39 -
Double-sided disc mowers
with central suspension
b)