Removing The I/O Module; Figure 7: Snap The I/O Module Into Place (Example); Figure 8: Removing The I/O Module (Example) - WAGO 750-637/040-001 Manual

WAGO-I/O-SYSTEM 750 XTR
750-637/040-001 Inc. Encoder 24 VDC Diff 32Bit XTR
2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 7: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or
to the previous or possibly subsequent I/O module are established.
6.2.2

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.

Figure 8: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Mounting 39
Manual
Version 1.1.0