Juniper MX10003 Hardware Manual page 156

CAUTION:
allow the fastened loops of a cable to dangle, which stresses the cable at the
fastening point.
CAUTION:
arc smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.
5. Insert the other end of the cable into the destination port.
6. Repeat the previous steps for any additional cables.
7. If the component is offline (its failure indicator LED is lit), use one of the following methods to bring
the it online:
To bring an MPC online:
Press and hold the OFFLINE button on the MPC until the green OK LED next to the button lights
steadily, in about 5 seconds. Use a narrow-ended tool that fits inside the opening that leads to the
button.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the
To bring a MIC online:
Press the MIC OFFLINE button until the OK/FAIL LED lights green. Use a narrow-ended tool that
fits inside the opening that leads to the button.
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
The normal functioning indicator LED confirms that the component is online. You can also verify correct
DPC or MPC functioning by issuing the show chassis fpc command or correct MIC or the PIC functioning
by issuing the show chassis fpc pic-status command.
Do not let fiber-optic cables hang free from the connector. Do not
Avoid bending a fiber-optic cable beyond its minimum bend radius. An
CLI Explorer.
CLI Explorer.
156