Installing An Mx10003 Mpc - Juniper MX10003 Hardware Manual

12. After you remove each MIC, immediately place it on an antistatic mat or in an electrostatic bag.
13. If you are not reinstalling an MPC into the emptied line card slots within a short time, install a blank
MPC panel over each slot to maintain proper airflow in the card cage.
CAUTION:
before reinserting it or inserting an MPC into a different slot.
Figure 51: Removing an MPC

Installing an MX10003 MPC

An MPC installs horizontally at the front of the router. The MPCs are hot-insertable and hot-removable.
A fully configured MPC can weigh up to 18.35 lb (8.3 kg). Be prepared to accept its full weight.
To install an MPC (see Figure 52 on page
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
2. Place the MPC on an antistatic mat.
3. Take the MIC to be installed in the replacement MPC out of its electrostatic bag.
4. Verify that each fiber-optic MIC has a rubber safety cap covering the MIC transceiver. If it does not,
cover the transceiver with a safety cap.
5. Install the MIC into the appropriate slot on the MPC.
6. Locate the slot in the card cage in which you plan to install the MPC.
After removing an MPC from the chassis, wait at least 30 seconds
152):
150