For more information about the command, see the
CAUTION:
removing the MPC again, removing an MPC from a different slot, or inserting an
MPC in a different slot.
You can also verify correct MPC and MIC functioning by issuing the show chassis fpc and show chassis fpc
pic-status commands.
Figure 52: Installing an MPC
SEE ALSO
Replacing a Cable on an MX10003 MPC or MIC | 154
Routine Maintenance Procedures for MX10003 Routers | 116
Prevention of Electrostatic Discharge Damage | 182
Maintaining Cables That Connect to MPCs or MICs
Purpose
For optimum router performance, verify the condition of the cables that connect to the MPCs or MICs.
Action
After the OK/FAIL LED lights steadily, wait at least 30 seconds before
CLI
Explorer.
152