Conveyor Belt Replacement And Adjustment Instruction - SaMASZ KDD 860 W Operator's Manual

1. In order to clean roller switch lever D, rotate belt to 1 and hold until bulges disappear (Fig. 41).
This should also be performed from the other side of conveyor if necessary.
Bulges
2. Impurities inside belt can be removed once conveyor is in vertical position. Belt is deflected by
hand and then impurities can be removed with a hook wire.

6.8.2. Conveyor belt replacement and adjustment instruction

Mower KDD 860/940 with conveyors must be suspended onto tractor. Lean the mower with
use of upper connector (cylinder) as far as you can to the front – in order to increase the distance
between conveyor and the ground.
I. The adjustment of the belt conveyor should be done only when the conveyor is in its
working position (horizontal).
1. Using a marker, mark lines on millimetre measures – decal 77 (if belts worked well).
2. Loosen tightening roller mechanism – screws M10 - S
adjustment screw M12 – S
Operator's manual
1
Fig. 41. Cleaning of conveyor rollers
Fig. 42. Removal of impurities inside the conveyor
by approx. 1.2" (Fig. 43).
2
- 46 -
Double-sided disc mowers
with central suspension
1
D
, nuts M12 – N
1
and loosen
2,