Table of Contents
Advertisement
HYDRAULIC - ENTIRE UNIT SETTLING
COULTER GANG PLUGGING
COULTER GANG WILL NOT TURN OR
PUSHES SOIL
COULTER BLADES LOOSE AND/OR SHEARING
ROLL PIN
5-2
Depth stop valve not working: repair valve
Operating depth too deep: raise unit.
Conditions too wet: wait until conditions more
favorable.
Depth set too deep for loose or wet conditions:
raise implement or wait until conditions are more
favorable.
Gang bearing failure: replace bearing
Gang not tightened properly: retighten gang shafts
to 1200-1500 ft-lbs. If gangs have ran loose, gangs
may require disassembly to remove soil to properly
torque gang shafts. Replace any worn components,
shafts/spools, etc.
Advertisement
Table of Contents
