Table of Contents
Advertisement
3-3 WHEEL LIFT INSTALLATION
3-3.1
Position the lift under the lift bearing
mount brackets on the frame assembly (See
Figure 3-2).
IMPORTANT
THE WHEEL LIFT ARMS SHOULD POINT TO-
WARD THE REAR OF THE MACHINE WITH
THE CYLINDER ANCHORS FACING UP.
3-3.2
Install the lift to the frame assembly us-
ing 3/4-10 x 2 hex head cap screws, lift bear-
ing caps, 4" bearings, and hex lock nuts.
3-3.3
Insert 1-5/8 x 1-1/4 x 1 bushing into
each cylinder mount plate of the shank lift.
3-3.4
Attach base end of the 3-1/2 x 16 hy-
draulic cylinder to the cylinder anchor plates
of the frame assembly using roll pin and
clevis pin supplied with the cylinder.
3-3.5
Attach rod end of each 3-1/2 x 16 hy-
draulic cylinder to the lift using roll pin and
clevis pin supplied with the cylinder.
o
3-3.6
Install 90
3-1/2 x 16 cylinders.
IMPORTANT
DO
NOT
USE
RESTRICTORS IN PORTS OF 3-1/2 X 16 HY-
DRAULIC CYLINDERS.
3-3.7
Attach leveler tube to leveler mount
plates on the lift using hitch pin, 1-8 hex lock
nut, and 1/2 x 2-1/4 slotted spring pin.
3-3.8
Assemble the tires to the hubs. Tighten
wheel bolts evenly to assure proper wheel
alignment. Wheel bolts should be tightened
to 90 ft-lbs of torque. The hoist can then be
removed.
3-3.9
Inflate the tire as recommended by the
manufacturer.
adapters in each port of both
o
90
ADAPTERS
WITH
3-5
Advertisement
Table of Contents
