Install The Left And Right Steering Hoses - Raven TC1 Installation Manual

C 3
HAPTER

INSTALL THE LEFT AND RIGHT STEERING HOSES

1. Locate the left and right steering lines on the orbital under the hood. Both hoses have twisted protective plastic
and the top hose (left) should have a blue marking.
FIGURE 18. Machine Orbital from Right Side of Machine
2. Remove the lines from the orbital using a crowfoot wrench and extensions.
3. Connect the Left and Right steering lines removed from the orbital to the supplied hoses (P/N 214-1001-214).
4. Route these hoses toward the dual POCI valve.
NOTE: Leave the dust caps on the opposite end of the supplied hoses until instructed to connect to the dual
POCI valve to avoid dirt and debris from contaminating the hydraulic system.
5. Connect the straight end of the supplied hoses (P/N 214-1001-213) to both ports of the machine orbital.
6. Route the hose connected to the top port of the orbital to port A on the dual POCI valve. Route the hose
connected to the bottom port of the orbital to port B on the dual POCI.
24
CAUTION
Use care when removing hoses to avoid breaking
the glass near the machine steering orbital.
TC1/HDU Installation Manual for Kubota M5 Series (Non-Steer Ready)
Disconnect Hoses
from Machine
Orbital