Install The Tank Hose; Install The Left And Right Steering Hoses - Raven SmarTrax Installation Manual

Connect the machine's pressure hose to the opposite end of the installed tee fitting.
4.
Install the 90° end of the supplied hydraulic hose (P/N 214-1000-318) on the 90° end of the installed tee
5.
fitting.
Connect the straight end of the installed hydraulic hose to Port P of the SmarTrax valve.
6.

Install the Tank Hose

Locate the machine's steel tank line.
1.
Note:
The pressure line runs on the inside of the frame from the rear of the machine. Trace it to the T
port on the steering orbital if necessary.
Disconnect the machine's tank hose from the steel tank line.
2.
Tank Hose Installed
FIGURE 7.
Install a -8 ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-028) on the machine's steel tank line.
3.
Connect the machine's tank hose to the opposite end of the installed tee fitting.
4.
Install the -8 end of the supplied hydraulic hose (P/N 214-1000-630) on the 90° end of the installed tee
5.
fitting.
Connect the other end of the installed hydraulic hose to Port T of the SmarTrax valve.
6.

Install the Left and Right Steering Hoses

Locate and disconnect the machine's left steering hose from the left steering cylinder.
1.
Note:
The left steering hose is connected to the fitting located closest to the center of the machine.
Route and connect the left steering hose to the Port A2 of the installed flow switch (P/N 334-0003-085).
2.
Manual No. 016-4001-081
Hydraulic System Installation
13