Disc Gang In Stal La Tion - Landoll 2220 Series Operator's Manual

3-8 DISC GANG IN STAL LA TION

IMPORTANT
READ ALL SAFETY PRE CAU TIONS AT THE
FRONT OF THIS SEC TION BE FORE AT TEMPT -
ING ANY OF THE FOL LOW ING PRO CE DURES.
DAN GER
DISC BLADES
SHARP. EX ER CISE EX TREME CARE
WHEN WORK ING ON OR NEAR DISC
BLADES. DO NOT AL LOW DISCS TO
ROLL OVER OR FALL ONTO ANY
BOD ILY PART.
WRENCHES TO SLIP WHEN WORK -
ING NEAR DISC BLADES. NEVER
PUSH WRENCHES TO WARD DISC
BLADES. DO NOT CLIMB OVER MA -
CHINE ABOVE DISC BLADES. FAIL -
URE TO STAY CLEAR OF DISC
BLADE EDGES CAN CAUSE SE RI -
OUS PER SONAL IN JURY OR DEATH.
Fig ure 3-10 Pivot Spacer Block In stal la tion
ARE EX TREMELY
DO NOT AL LOW
3-8.1 FRONT DISC GANG IN STAL LA TION.
IMPORTANT
THE FRONT DISC GANG FRAMES ARE THE
SHORTER PAIR.
a. In stall the pivot block on the outer disc gang
frame pivot so the long end is fac ing the rear
of the frame.
b. Hoist the disc frame up un til the disc frame
arm goes into the in ner mount ing bracket on
the main frame. Lo cate the disc gang so that
the pivot block is be hind the outer mount ing
bracket.
c. Align the pivot block with the outer mount ing
bracket and slide it for ward.
d. In stall a hitch pin through the in ner mount -
ing bracket and the ball socket of the disc
frame arm. Se cure with cot ter pins.
e. In stall a bush ing in the outer frame bracket
by put ting a 1" x 6" bolt up through the
bracket and a nut on the top.
IMPORTANT
MAKE SURE THE NUT IS ON TOP.
f. Two an gle ad just pins are in stalled in the
outer mount ing bracket with hair pins. Make
sure an gle ad just pins are as sem bled as
shown in Fig ure 3-9. These an gle ad just pins
are used to ad just the an gle of the disc
gangs.(See Sec tion 4-4.7).
3-8.2 REAR DISC GANG IN STAL LA TION.
a. In stall the pivot block on the outer disc gang
frame pivot so the long end is fac ing the front
of the frame.
b. Hoist the disc frame up un til the disc frame
arm goes into the in ner mount ing bracket on
the main frame. Lo cate the disc gang so that
the pivot block is in front of the outer mount -
ing bracket.
c. Align the pivot block with the outer mount ing
bracket and slide it rear ward into the bracket.
d. In stall a hitch pin through the in ner mount -
ing bracket, the ball socket of the disc frame
arm and the pivot spacer (See Fig ure 3-10).
Se cure with cot ter pins.
3-15