Custom Settings; How To Permanently Change The Factory Default Settings; Fast Boot Mode - Opticon MDI-4000 Series Serial Interface Manual

3.2.3

Custom Settings

To save Active Settings to Custom Settings, send the [BAQ command at the end of command
packet you want to save. To save Custom Settings and Active Settings at same time, send the
[BAQZ2 command.
Custom Settings Commands
Command Description
[BAP Read out Custom Settings
[BAQ Save to Custom Settings
* Saving Custom Settings over 100,000 times may destroy memory. If you need to configure these settings
frequently, avoid saving every time.

3.3 How to Permanently Change the Factory Default Settings

You can use the Custom Command Line commands to permanently change the Factory Default
Settings. The new Factory Default Settings become active after the scan engine is rebooted and
initialized and persist through a firmware update.
Note: Custom Command Line commands may corrupt flash memory if power is turned off while
they are being configured. Only use these commands in an environment where the power is
stable.
Recommended Custom Command Line Settings:
•
Fast Boot Mode (See
•
Image settings (See
•
Serial communication commands like baud rate, data length, parity, and stop bit.
"UART" on page
Custom Command Line Commands
Command Command
Header
<ESC> [EFY
* Multiple commands are allowed.
To activate the new Factory Default Settings, send or scan the RV command to reset the scan
engine.
To load the new Factory Default Settings, send or scan the U2 command to save the new
settings and load them after the scan engine is powered up.
"Fast Boot Mode" on page
"Mirrored Image" on page
19.)
Separator Command IDs*
'
Custom Commands
(0x27)
MDI-4000 Series Serial Interface Manual
12.)
15.)
Separator
'
(0x27)
(See
Command
Terminator
<CR>
11