Usb-Com Interface Signal - Opticon MDI-4000 Series Serial Interface Manual

MDI-4000 Series Serial Interface Manual
4.2.2

USB-COM Interface Signal

An IRISO Electronics Co., Ltd. 9681-12(12PIN) (bottom contact) equivalent connector is used.
No. Name
1 TRIGn
2 AIM/WAKEn
3 GR_LEDn
EX_ILLUM
4 BUZZERn
5 POWERDWN
6 RTS
7 USB+
8 TxD
9 USB-
10 GND
11 VCC
12 Reserve
*1
When this is set, Good Read LED cannot be used.
*2
Tone and sound pressure are controlled by the pulse-width modulation (PWM) signal.
28
Function I/O
Trigger In
Recovery signal In
from Low Power
state
Aiming control In
signal in other
states than Low
Power
Good read LED Out
Control of an Out
external light
source.
Buzzer Out
Indicates Low Out
Power state
Communication Out
control signal to
host system
Communication In/Out
control signal
from host
system
Transmitted Out
data signal
Received data In/Out
signal
System ground
Power input In
In
Conditions State
L: Start operation
L: Recover from
low power state
H: No action
L: Aiming LED on
H: Aiming LED
off
L: LED on
H: LED off
*1
Configured L: External
Illumination On
H: External
Illumination Off
L: Normal state
H: Low Power
state
Put it to Open.
Put it to Open.
3.3V or 5.0V
Notes
100kΩ pull up
on module
4.7kΩ pull up
on module
100kΩ pull up
*2
on module
100kΩ pull up
on module
10kΩ pull up
on module
100kΩ pull up
on module
10kΩ pull up
on module
N.C