8.4.2
External LED Illumination
You can enable external LED illumination to improve barcode reading performance. When
external LED illumination is enabled, the scan engine provides an output signal on pin-3. To
activate and save the new configuration, you need to send the Z2 command.
LED Output Mode (Pin3) Commands
Command
[D26
[D28
8.4.3
LED Aiming
You can enable or disable the green aiming LED, as well as configure the brightness.
LED Aiming Commands
Command
[D3D
[D3E
LED Aiming Brightness Commands
Command
[DDD
[DDE
[DDF
8.5 Batch Reading
You can configure batch reading for fixed format barcodes.
Note: The data edit/extract reading function is supported by the scan engine but is not available
in "UniversalConfig2.0". For help, contact your local Opticon Representative.
Configure Batch Reading
1. Start the Opticon UniversalConfig application and click Multi label.
Description
Disable external LED illumination signal
(Enables Good Read Output Signal)
Enable external LED illumination signal
(Disables Good Read Output Signal)
Description
Enable LED aiming
Disable LED aiming
Description
High brightness
Standard brightness
Low brightness
MDI-4000 Series Serial Interface Manual
Default
✓
Default
✓
Default
✓
97