Sending Command Packets; Figure 5: Opticon's "Universal Config - Opticon MDI-4000 Series Serial Interface Manual

Input examples:
1-digit command
2-digit command
3-digit command
Two 4-digit commands
2-digit and 3-digit command
You can send the command through Opticon's "UniversalConfig." For help, contact your Opticon
Sales Representative.
Note: In UniversalConfig, <ESC> is automatically sent.

Figure 5: Opticon's "Universal Config"

3.1.2

Sending Command Packets

The maximum length of a command packet is 1000 characters. If more than 1000 characters
are sent, the scan engine may lose some characters and the command packet may not be
processed correctly.
If you send a packet that contains 32 or more characters and the baud rate is set to 460800 or
921600, the scan engine may miss part of the command. To use these baud rates, split up
commands into packets that contain less than 32 characters.
<ESC>Δ<CR>
<ESC>ΔΔ<CR>
<ESC>[ΔΔΔ<CR>
<ESC>ΔΔΔΔ<CR>
<ESC>ΔΔ[ΔΔΔ<CR>
MDI-4000 Series Serial Interface Manual
7