Ags Menu; Meter Menu; Figure 3-4, Ags Menu Display; Figure 3-5, Meter: 01 Inv/Chg Meter Display - Magnum Energy ME-RC Owner's Manual

3.2.2 AGS Menu

The AGS menu pushbutton allows the optional Auto Generator Start (AGS)
controller (if installed and networked) to be configured to your specific system
preferences and check status of the AGS.
Info: Refer to the ME-AGS-N Owner's Manual (part number: 64-
0005) for detailed information on the Magnum Energy Auto Generator
Start (ME-AGS-N) and this menu.

Figure 3-4, AGS Menu Display

3.2.3 METER Menu

Pressing the METER menu pushbutton gives you access to different meters,
which helps determine the status of the inverter/charger and battery sys-
tem.
• METER: 0 INV/CHG Meter - This menu provides the DC voltage and
current while either inverting or charging.
The DC: V (Volts) display provides the voltage from the batteries connected to
the inverter. The DC: V accuracy is ±1.5% with a 0.1 VDC resolution.
While inverting, the DC: A (Amps) displays a negative number to show the
battery current used by the inverter. If you are charging, the DC A (amps)
displays a positive number to show the amount of current delivered to the
batteries. The accuracy of this display below 1 amp AC (~10 amps DC @
12VDC) is not detected. When the current into or out of the batteries is
greater than 1 amp AC, the display accuracy is ±20%.
METER
Status...
01 INV/CHG Meter
press

Figure 3-5, METER: 01 INV/CHG Meter Display

• METER: 02 BM: SOC thru 0 BM: TECH - These menus allow the
optional ME-BMK (Magnum Energy's Battery Monitor Kit) - if installed - to be
configured to your specific system preferences and display the status of the
battery system; refer to the ME-BMK Owner's Manual (part number 64-
0013) for detailed information on the Battery Monitor Kit and these menus.
©2009 Magnum Energy Inc.
Status...
01 AGS Control
SH OR E AGS
press
display show s
m enu item :
METER SETU P TEC H
press to select
3.0 Setup
display show s
D C m eter:
Status...
DC: **V **A