Install The Node Harness; Install The Foot Switch; Install The Valve Harness - Raven SmarTrax Installation Manual

Secure the SmarTrax node (P/N 063-0173-228) to the node mounting plate using three 3/8"-16 nyloc nuts
3.
(P/N 312-4000-061).

Install the Node Harness

Install the two large, rectangular connectors of the node harness (P/N 115-4001-109) into the correct ports
1.
of the node.
Tighten the bolts on the harness connectors to secure the connections.
2.
Connect the node harness to the installed power cable (P/N 115-4001-085), if applicable.
3.

Install the Foot Switch

Foot Switch Installed
FIGURE 4.
Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
1.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
2.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
3.
Locate the ENABLE connector on the node harness and connect it to the foot switch cable connector.
4.

Install the Valve Harness

Locate the valve harness (P/N 115-4001-122).
1.
Route the 12-pin connector toward the node harness (P/N 115-4001-109).
2.
Plug the 12-pin connector of the valve harness into the mating connector of the node harness.
3.
Route the valve harness through the bottom of the cab.
4.
Manual No. 016-4001-006
Cab Component Installation
23