Led Indicators Ethernet; Important Information For System Integrators - Leuze electronic DDLS 200 Series Original Operating Instructions

10.5

LED indicators Ethernet

In addition to the indicators and operational controls present in all device models (bar graph, buttons,
LEDs AUT, MAN, ADJ; see chapter 11.1 "Indicators and operational controls"), the Ethernet model
also has the following indicators:
PWR LINK Rx/Tx
100 FDX BUF
Figure 10.9: Indicators and operational controls of the Ethernet model
10.6

Important information for system integrators

ATTENTION!
The notices provide initial information and describe the working principles of the optical
data transceiver with Ethernet.
The notices must be read by each user before the first commissioning of the DDLS 200
with Ethernet.
Possible restrictions in the time behavior of the optical data transmission in comparison to
copper-based data transmission are described here.
Using the DDLS 200 for Ethernet, 10Base-T or 100Base-TX with 2MBit is transmitted optically e.g. to
a moving conveyor system where it is then converted back into 10Base-T or 100Base-TX.
The DDSL 200 is connected to the Ethernet via a twisted pair port with an RJ45 connector or an M12
connector. An external switch reduces the data flow along the optical transmission path by filtering the
messages. Only messages for participants located downstream of the optical data transmission path
are actually transmitted. The data throughput rate of the optical path is max. 2MBit/s.
Leuze electronic
LED PWR: green
green flashing= transmitter / receiver unit switched off
AUT
MAN
ADJ
off
LINK LED: green
off
Rx/Tx LED: green
red
orange
off
100 LED: yellow
off
FDX LED: yellow
off
BUF LED: yellow
off
DDLS 200
= operation indicator.
via switching input IN or hardware error.
= no operating voltage.
= LINK OK.
= no LINK present.
= data is being received by the bus.
= data is being transmitted to the bus.
= data is being received by the bus or
transmitted to the bus simultaneously.
= no data is being received by the bus or
transmitted to the bus.
= 100Base-Tx connected
= 10Base-T connected
= full duplex (Full-Duplex)
= half duplex
= internal buffer (Buffer) full,
message rejected.
= message not rejected.
Ethernet
57