Leuze electronic DDLS 200 Series Original Operating Instructions page 31

WARN WARN PE PE GND
Out IN
S1
H2 H2 H1 H1
Out In
Bus Bus
500K
2M
S2
Figure 7.1: Connection board of the INTERBUS model
ATTENTION!
Please be sure to observe the installation requirements defined in the INTERBUS stan-
dard EN 50254 and follow the handling and installation specifications for fiber-optic cables
as specified by the manufacturer.
For the FOC guides, use only the large screwed cable gland M20x 1.5.
beyond the specified minimum bending radius given for the FOC type used! Observe the
maximum FOC length!
Leuze electronic
OUT OUT
GND Vin Vin
IN IN PE PE GND GND Vin Vin
IN
Off
On
S3
INTERBUS - terminals and switches
FOC socket Function
H1 Receiver fiber-optic cable
H2 Transmitter fiber-optic cable
Switch Function
S2 Position 500k: INTERBUS FOC trans-
Position 2M (default):
S3 Position In Bus (default):
Position Out Bus: outgoing bus fiber-
DDLS 200
INTERBUS 2MBit/s FOC
mission rate 500kBit/s
INTERBUS FOC trans-
mission rate 2MBit/s
incoming bus fiber-
optic cable
optic cable
Do not bend
29