Epson C12 Series Manipulator Manual page 297

Removal: LED lamp
1. Turn OFF the Controller power.
2. Remove the Arm #3 cover.
For details, refer to Maintenance: 3. Covers.
3. Remove the connector connected to the LED lamp.
The connector for the LED lamp (LED) is under the Arm #3 cover.
Connector: LED
4. Remove the LED lamp from the Arm #3.
Turn the plastic nut securing the LED lamp in the Arm #3
counterclockwise.
Installation: LED lamp
1. Install the LED lamp to the Arm #3.
Remove the plastic nut from the LED lamp.
Pass the lamp from the inside of the Arm #3.
Turn the nut clockwise and secure the lamp to the Arm #3.
2. Connect the following connector.
Connector: LED
3. Install the Arm #3 cover.
For details, refer to Maintenance: 3. Covers.
C12 Rev.3
Maintenance 13. Replacing the LED Lamp
Plastic nut
283