R# (Reset Number); Tr (Transmission Failure Count) - Digi XTend vB DigiMesh XTP9B-DPM-001 User Manual

Parameter range
(read-only): 40 - 110 [dBm]
Default
N/A

R# (Reset Number)

Provides the reason for the last device reset.
Parameter range
0-5
Parameter
0
2
3
4
5
Default
0

TR (Transmission Failure Count)

This count increments whenever a MAC transmission attempt exhausts all MAC retries without ever
receiving a MAC acknowledgment message from the destination node. Once the number reaches 0xFFFF,
it does not count further events. To reset the counter to any 16-bit value, append a hexadecimal
parameter to the command.
This value is volatile (the value does not persist in the device's memory after a power-up sequence).
Parameter range
N/A
XTend vB DigiMesh RF Module User Guide
Description
Power up reset
Watchdog reset
Software reset
Reset line reset
Brownout reset
Diagnostic commands
42