Mounting The Expansion Interface Card; Mounting The 080E-B1/008E-B1/000E-B1 /1Priu-C1 Pcbs; Figure 2-53 Removing The Sub-Cover; Figure 2-54 Removing The Main-Cover - NEC SL1100 Hardware Manual

SL1100
3.3

Mounting the Expansion Interface Card

DO NOT POWER ON until all installation has been completed.
Fit the optional 4COIDB-B1/2BRIDB-C1 daughter boards before installing the
084M-B1/080E-B1/008E-B1/000E-B1 PCBs.
Set the switches on the 2BRIDB-C1 board before mounting it onto the 084M-B1/080E-B1/
008E-B1/000E-B1 PCB.
3.3.1

Mounting the 080E-B1/008E-B1/000E-B1 /1PRIU-C1 PCBs

The procedure for mounting the expansion interface cards is as follows;
Do Not Power on until all installation have been completed.
1. Turn off the system power and disconnect the AC cord from KSU.
2. Open and remove the Sub-Cover.
3. Loosen two screws and remove the Main-Cover.
2-34

Figure 2-53 Removing the Sub-Cover

Figure 2-54 Removing the Main-Cover

ISSUE 1.0
Installation