Ip4Ww-Battery Box Fuse Replacement; Figure 2-44 Connecting Battery Cable - NEC SL1100 Hardware Manual
Hide thumbs
Also See for SL1100:
- Features and specifications manual (864 pages) ,
- Programming manual (650 pages) ,
- Networking manual (292 pages)
Table of Contents
Advertisement
ISSUE 1.0
4.
Connect Battery cable from the Battery box to Battery connector on the KSU.
2.8
IP4WW-Battery Box Fuse Replacement
In the event of a blown fuse correct the fault causing the fuse to blow before
replacing the fuse; otherwise you may cause fire or electrical hazards.
Be sure to use only the specified fuse (250VT8AL).
Be sure to install the fuse into the correct location.
Be careful not to burn yourself on the heated fuse. The blown fuse may be heated
soon after blowing.
1.
Power off the KSU and disconnect AC cord.
2.
Loosen two screws and remove the Front Cover.
Hardware Manual
Figure 2-44 Connecting Battery Cable
SL1100
2-29
Advertisement
Table of Contents
