RIGOL
To Set the GPIB Address
Before using the GPIB bus to control the oscilloscope, use the USB-GPIB interface
converter (an option that requires to be ordered separately) to extend the GPIB
interface, and then use the GPIB cable to connect the instrument to the PC. Press
Utility → IO → GPIB, then rotate the multifunction knob
GPIB address or use the pop-up numeric keypad to input the GPIB address. Its
settable range is from 1 to 30. By default, it is 1.
To Set HDMI
Sets the status and parameters of the HDMI video output interface on the rear panel.
Note that only when the HDMI interface is connected, can this menu be enabled.
Press HDMI to enter the HDMI setting menu.
Press Output continuously to enable or disable the video output.
⚫
ON: You can connect the instrument to an external display via this interface
➢
to better observe the waveform display clearly from the external display.
OFF: disables the interface.
➢
Press Resolution to set the screen resolution. The available resolution includes
⚫
640x480 , 720x480
USB Connection
The oscilloscope can communicate with a PC via the USB DEVICE interface on the
rear panel. No parameters are required to be configured.
20-6
1280x720.
, and
Chapter 20 System Utility Function Setting
directly to set the
MSO5000-E User Guide