To Select The Histogram Source; To Set The Histogram Height; To Set The Histogram Range; To Enable Or Disable The Statistical Function - Rigol MSO5000-E Series User Manual

Chapter 9 Histogram Analysis
RIGOL

To Select the Histogram Source

If "Horizontal" or "Vertical" is selected under Type, you need to set the source
(CH1-CH2). Press Source, then rotate the multifunction knob to select the
desired source, and then press down the knob to select the source. You can also
press Source continuously or enable the touch screen to select it.
When you select "Measure" as the histogram type, press Measure on the front
panel to enter the measurement setting menu, and then add one or multiple
measurement items. The added measurement item(s) can be served as the
histogram source(s).

To Set the Histogram Height

The histogram height indicates the number of grids the histogram bar graph should
use on the screen. Press Height, then rotate the multifunction knob or use the
pop-up numeric keypad to set the height. The available range of height is from 1 to 4.
By default, it is 2.

To Set the Histogram Range

When "Horizontal" or "Vertical" is selected under Type, you need to set the window
range. Set "Left Limit", "Right Limit", "Top Limit", and "Bottom Limit" respectively to
adjust the size and position of the histogram window. Press Range to enter the
sub-menu of histogram range. Then press the corresponding softkey and rotate the
multifunction knob to set their values.
Note: The adjustment for the horizontal timebase and vertical scale will not affect
the timebase of the histogram range, but only shows variation with the scale.

To Enable or Disable the Statistical Function

Press Statistic to enable or disable the statistical function. When the statistical
function is enabled, the statistical results of the histogram data will be displayed, as
shown in the following figure. Note that when you select "Measure" under Type, the
statistical data results also include the parameter XScale.
MSO5000-E User Guide 9-3