Rigol MSO5000-E Series User Manual page 218

RIGOL
is an odd number. For example, when 0x55 (01010101) is sent, "1"
should be added to the check bit.
Stop Bit
⚫
Press Stop Bit and rotate the multifunction knob
after each frame of data. Press down the knob to select it. You can also
press Stop Bit continuously or enable the touch screen to select it. It can
be set to 1 bit, 1.5 bits, or 2 bits.
Endian
⚫
Press Endian to select "LSB" or "MSB". By default, it is "LSB".
LSB: indicates Least Significant Bit transmission sequence, i.g. the lowest
bit of the data is transmitted first.
MSB: indicates Most Significant Bit transmission sequence, i.g. the highest
bit of the data is transmitted first.
Package
⚫
Press Package to enable or disable the package display in data
transmission. When enabled, several data blocks will be combined based on
the separator.
Separator
⚫
Press Separator and rotate the multifunction knob
desired package separator in data transmission, then press down the knob
to select it. You can also press Separator continuously or enable the touch
screen to select it. It can be set to 0A(LF), 0D(CR), 20(SP), or 0(NUL).
6． Display-related setting
Press Display to enter the display setting menu.
Set the display format
⚫
Press Format, rotate the multifunction knob
format of the bus data. Then, press down the knob to select it. You can also
press Format continuously or enable the touch screen to select it. The
available display formats of the bus data are "Hex", "Dec", "Bin", and
"ASCII".
11-10
LSB
Chapter 11 Protocol Decoding
to set the stop bits
MSB
to select the
to select the display
MSO5000-E User Guide