Video Trigger - Rigol MSO5000-E Series User Manual

Chapter 5 To Trigger the Oscilloscope

Video Trigger

The video signal can include image information and timing information, which adopts
different standards and formats. MSO5000-E series can trigger on the standard video
signal field or line of NTSC (National Television Standards Committee), PAL (Phase
Alternating Line), or SECAM (Sequential Couleur A Memoire).
Trigger Type:
Press Type, and then rotate the multifunction knob
down the knob to select the trigger type. Then, the current trigger setting
information is displayed at the upper-right corner of the screen, as shown in the
figure below. You can also press Type continuously or enable the touch screen to tap
the desired trigger type and select it.
Source Selection:
Press Source to switch the trigger source and select CH1-CH2. For details, refer to
descriptions in "Trigger Source". The current trigger source is displayed at the
upper-right corner of the screen.
Note: Only when we select the channel (that has been input with signals) as the
trigger source, can we obtain a stable trigger.
Video Polarity:
Press Polarity continuously to select the desired video polarity. The polarities
available are positive polarity ( ) and negative polarity ( ).
Video Standard:
Press Standard and rotate the multifunction knob
standard. You can also press Standard continuously to select the video standard or
enable the touch screen to tap the desired video standard and select it.
Video Frame Frequency
Standard (Frame)
NTSC 30
PAL/SECAM 25
480p/60Hz 60
576p/50Hz 50
720p/60Hz 60
720p/50Hz 50
720p/30Hz 30
720p/25Hz 25
720p/24Hz 24
1080p/60Hz 60
1080p/50Hz 50
MSO5000-E User Guide
to select "Video". Press
to select the desired video
Scan Type
Interlaced Scan
Interlaced Scan
Progressive Scan
Progressive Scan
Progressive Scan
Progressive Scan
Progressive Scan
Progressive Scan
Progressive Scan
Progressive Scan
Progressive Scan
RIGOL
TV Scan Line
525
625
525
625
750
750
750
750
750
1125
1125
5-15