System Time - Rigol MSO5000-E Series User Manual

RIGOL
The press SINGLE to switch to the next touch screen test interface, as shown
in the figure below. At this time, you can pinch or stretch the RIGOL logo on the
screen to zoom it out or in to check whether the gestures work normally. Press
RUN/STOP for three consecutive times to exit the touch screen test interface.

System Time

The system time is displayed at the lower-right side of the screen in "hh:mm
(hour:minute)" format. When you save the waveform, the output file will contain the
time information.
Press Utility → More → More → Time to open the time setting menu.
1. Set the System Time
(1) Press Show Time to open or close the system time interface.
(2) Set "year": Press Year, rotate the multifunction knob
or use the pop-up numeric keypad to input the numeric value to set it.
(3) Set "month": Press Month, rotate the multifunction knob
set it or use the pop-up numeric keypad to input the numeric value to set it.
(4) Set "day": Press Day, rotate the multifunction knob
use the pop-up numeric keypad to input the numeric value to set it.
(5) Set "Hour": Press Hour, rotate the multifunction knob
or use the pop-up numeric keypad to input the numeric value to set it.
(6) Set "Minute": Press Minute, rotate the multifunction knob
set it or use the pop-up numeric keypad to input the numeric value to set it.
The setting range of each item of the system time conforms to the convention.
Year: 2017 to 2099
⚫
Month: 01 to 12
⚫
Date: 01 to 31 (28, 29, or 30)
⚫
Hour: 00 to 23
⚫
Minute: 00 to 59
⚫
20-18
Chapter 20 System Utility Function Setting
MSO5000-E User Guide
directly to set it
directly to
directly to set it or
directly to set it
directly to