National Restrictions; Operating Frequency; Federal Communications Commission (Fcc) Statement; Fcc Interference - Teldat M1 Installation Manual

Teldat S.A.

4.7 National restrictions

In accordance with article 10 of 2014/53/EU, we hereby inform you that national usage restrictions and requirements
may apply to the device. The requirements for any country might change. We recommend that you check with your
local authorities for the latest status of national regulations.
This product is supplied with antennas to meet local regulations. Do not use other antennas with this product. To
comply with power limits and RF exposure requirements, the antennas used with this transmitter must be installed to
provide a separation distance of, at least, 25 cm from all persons.

4.8 Operating frequency

To find out more about operating frequencies, see Appendix
tions on page 33

4.9 Federal Communications Commission (FCC) statement

4.9.1 FCC interference

This equipment has been tested and complies with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to a different outlet so that the equipment and receiver are on different circuits.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
Authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including in-
terference that may cause undesired operation.

4.9.2 FCC radiation exposure statement

This equipment complies with FCC radiation exposure limits for an uncontrolled environment. It should be installed
and operated leaving a minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

4.9.3 Radio frequency interference requirements

This device is restricted to indoor use due to its operation in the 5.15 - 5.25 GHz frequency range.
The FCC requires this product to be used indoors to reduce the potential for harmful interference to co-channel Mo-
bile Satellite systems.
High power radars are allocated as primary users of the 5.25 - 5.35 GHz and 5.65 - 5.85 GHz bands. These radar
stations can cause interference with and/or damage this device.
Teldat Router M1/M1L
WWAN specifications on page 33 and
4 Compliance
WIFI specifica-
25