National Restrictions; Operating Frequency; Fcc Statement; Federal Communications Commission Interference - Teldat M1 Installation Manual

Teldat S.A.

4.7 National Restrictions

In accordance to article 10 of 2014/53/EU we inform you that there may be national restrictions and requirements for
authorization. The requirements for any country may evolve. Teldat S.A. recommends that you check with local au-
thorities for the latest status of their national regulations.
This product is supplied with antennas in order to fulfill the local regulation. Do not choose another antennas. To
comply with power limits and RF exposure requirements,the antennas used for this transmitter must be installed so
that people keep a separation distance of, at least, 25 cm.

4.8 Operating Frequency

To check the operating frequencies working in the device, see Appendix
GSM/WCDMA Specifications

4.9 FCC Statement

4.9.1 Federal Communications Commission Interference

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resid-
ential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from the one the receiver is connected to.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
Authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including in-
terference that may cause undesired operation.

4.9.2 FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits for an uncontrolled environment. This equipment should
be installed and operated leaving a minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

4.9.3 Radio Frequency Interference Requirements

This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range.
The FCC requires this product to be used indoors to reduce the potential for harmful interference to co-channel Mo-
Teldat Router M1/M1L
on page 33 andWIFI Specifications
RF LTE Specifications
on page 34
4 Compliance
on page 33 ,RF
25