Section 6: Operating Procedures; Machine Setup - Taylor PH61 Operator's Manual

Section 6

Machine Setup

Evaluate the condition of lights and screen messages
(HARD LOCK or SOFT LOCK, etc.) before performing
opening procedures. If all four LEDs on the front of the
machine are lit, the machine is locked. (See Figure 6-1.)
Figure 6-1
We begin our instructions at the point when we enter the
store in the morning and find the parts disassembled and
laid out to air-dry from the previous night's cleaning.
These opening procedures will show you how to
assemble these parts into the freezer, sanitize them, and
prime the freezer with fresh mix in preparation to serve
your first portion.
If you are disassembling the machine for the first time or
need information to get to the starting point in our
instructions, turn to the Closing Procedures on 
page 6-17 and start there.
Freezing Cylinder Assembly
WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
Operating Procedures
Operating Procedures
With the parts tray available:
1. Before installing the shake beater driveshaft,
lubricate the groove on the beater driveshaft. Slide
the beater driveshaft boot seal over the small end of
the beater driveshaft and engage into the groove on
the shaft. Heavily lubricate the inside portion of the
boot seal, and also lubricate the flat end of the boot
seal that comes in contact with the rear shell bearing.
Apply an even coat of lubricant to the shaft. Do not
lubricate the square end. (See Figure 6-2.)
Note: When lubricating parts, use an approved
food-grade lubricant (example: Taylor Lube HP).
Apply the appropriate
Taylor approved food safe lubricant.
Note: To ensure that the mix does not leak out of
the back of the freezing cylinder, the middle section
of the boot seal should be convex or extend out from
the seal. If the middle section of the boot seal is
concave or extending into the middle of the seal, turn
the seal inside out. (See Figure 6-3.)
PH61 Peristaltic Pump
Figure 6-2
Figure 6-3

6

11155
6-1