Taylor PH61 Operator's Manual page 61

Problem
12.Excessive mix leakage
into the long drip pan.
13.The driveshaft is stuck
in the drive coupling.
14.Freezing cylinder walls
scored.
15.Spinner shaft will not
rotate to blend mix and
syrup.
16.Large adjustments are
necessary to receive 
1 oz. (30 ml) in 
5 seconds.
17.Pump will not operate in
the Pump mode.
Troubleshooting Guide
Probable Cause
a. The seal on driveshaft is
improperly lubricated or worn.
b. The seal is installed inside out on
the driveshaft.
c. Worn or missing O-rings on pump
driveshaft.
d. Inadequate lubrication of the
driveshaft.
e. The driveshaft and beater
assembly worked forward.
f. Worn rear shell bearing.
g. Gearbox is out of alignment.
a. Mix and lubricant collected in drive
coupling.
b. Rounded corners of driveshaft,
drive coupling, or both.
c. Gearbox is out of alignment.
a. Missing or worn front bearing.
b. Broken beater pins.
c. Gearbox is out of alignment.
a. Flexible coupling is broken.
b. Pin is missing in quick disconnect
of spinner coupling.
c. Spinner motor is out on thermal
overload.
a. The pump tube has collapsed.
b. Syrup lines are not matched with
correct syrup flavor.
c. The plunger is sticking in the syrup
valve.
d. Plugged syrup line fitting at freezer
door connection.
e. Verify that the proper syrup
selection was made.
a. Pump motor is not activated.
b. The membrane switch is defective.
Burger King PH61
TROUBLESHOOTING GUIDE
Corrective Action
a. Lubricate properly or replace the seal.
b. Install correctly.
c. Install or replace the O-rings.
d. Lubricate properly.
e. Call a Taylor service technician.
f. Call a Taylor service technician.
g. Call a Taylor service technician.
a. Brush-clean the rear shell bearing area regularly.
b. Call a Taylor service technician.
c. Call a Taylor service technician.
a. Install or replace the front bearing.
b. Repair or replace the beater assembly. When
installing scraper blades, make sure they are
properly attached over the pins.
c. Call a Taylor service technician.
a. Call a Taylor service technician.
b. Call a Taylor service technician.
c. Allow the spinner motor to cool. Also check
lubrication on spinner shaft. Properly align the motor
and lubricate properly.
a. Replace the pump tube.
b. Match the color wrapped syrup lines to the correct
syrup flavors.
c. Clean the valve.
d. Clean the syrup line fitting.
e. Make the proper syrup selection.
a. Push the reset button.
b. Call a Taylor service technician.
8
8-3