Set The Down Pressure - CONCORD NT30 Operator's Manual

3. Operation
4. Put a checkmark in the box (1) for the section
to be calibrated.
5.
Use the keypad outside the machine to start
and stop the motors.
The #1 button controls the front hopper and
the #2 button controls the rear hopper.
6. Weigh container for each product.
Use the scale supplied to weigh the container.
7. Calculate the catch weight.
Subtract the container weight from the total to
get the catch weight.
8.
Enter the catch weight value (2) for each
product.
9. Select to go back to the main screen.

3.22.3 Set the down pressure

Procedure
1.
Select the box (1) below
specific value.
2. Use the number pad to enter the down
pressure value.
3. Select .
4. Select to move between two preset
down pressure values.
5. To change the preset values or the other
values all on one screen,
select right side of the screen.
Fig. 63
to enter a
on the
Fig. 64
98
GUID-AEAF47D4-D637-4049-8A3E-4C8D7AB68D3E-high.jpg [High]
GUID-88E440FA-F602-4D8E-B956-4D4A82B042D1 [V2]
GUID-1D1CBF65-448D-47C6-B7A5-5D9DA4A7FB11-high.jpg [High]
Narrow-Transport Grain
Drill (322782B)